Fluid Flow Calibration For 3D Printing, An Engineering Approach

Material flow in Fused Filament Fabrication has two points of interest. The first is the drive system and the second is the deposition or extrusion point. Here are instructions on how to tune filament flow.

Read more...

Pimp my Printer: Installing Custom LED Bar – #MAKEMORE Salvatore Lacorte

add plug-and-play LED lighting to virtually any 12V or 24V 3D printer, no soldering is required, and installation takes just minutes on most machines. Cables connect to either the PSU via pre-soldered and crimped spade connectors, or directly to hot end fan power, with no additional wiring needed.

Read more...

Solidworks Tutorial for a 3D Printer by Dan Salvadore of Tesla Filaments

Dan Salvadore of Tesla Filaments demonstrates 3D Printer Clibration Techniques for 3D Printing Club Members

Read more...